STEP 1
Make 10 partitions. Two of these in the upper area are separated by a zigzag.
STEP 2
One in the area of the parietal bone and two partitions in each of the temporal areas.
STEP 3
At the back, make 3 partitions, an inverted triangle in the center and two symmetrical partitions on either side.
STEP 4
In the left temporal area, we create radial sections with the vertex in the lower section.
STEP 5
Starting in the central section, we cut at an elevation of 90°, a finger angle of 45°, moving towards the center, leaving 3 cm in the lower part. We carry out the same technique on the right temporal area.
STEP 6
In the back partition in an inverted triangle shape, we create vertical sections.
STEP 7
Starting from the central section, we cut with an elevation of 90°, a interior finger angle of 45°, moving towards the center, leaving a length of 3 cm in the lower part.
STEP 8
In the parietal area partition, we create radial sections with the vertex at the apex.
STEP 9
We cut with an elevation of 90°, a finger angle of 90° to the base of the hair and using the length of the lower partition as a guide measure.
STEP 10
We cut the upper partition in vertical sections.
STEP 11
With an elevation of 90° and a finger angle of 90°to the base of the hair and using the lower partition as a guide measure.
STEP 12
In the rear partitions of the sides, we use the razor cut technique using the central lock as a guide and getting longer from the center to the sides.
STEP 13
We also use the razor cut technique on the remaining temporal partitions, thinning out the temple areas towards the face.
STEP 14
The bangs or fringe area is also worked using a razor cut above the eyebrows.